Harmony II Wrap erases the harmful effects of smart meter comms channels and harmonics from the electrical grid; including switch mode harmonics from utilities and telecommunication magnetic interactions.  The Harmony II Wrap is classified as clean tech that provides frequency-perfect power factor correction and 2nd, 4th, and 16th harmonic. Multi-layered harmonic correction allows us to place your home in a purified electromagnetic “bubble” to protect your home against incoming harmful electromagnetic radiation. Our Harmony II Wrap is based on a Planar design to utilize the entire surface area of the Wrap as a non-limiting, parallel, low pass nullifying inductive coil. Our Wrap provides a minimum of -96dB of noise reduction evenly disbursed up to 325GHz.
 
For home protection, Harmony II Wrap “detoxes” your body from the harmful electromagnetic disruptions of the day as you walk into your home, experiencing a pure detoxification relaxation as your body drains all the stored bad energy of the day away. As part of an Alan Maher Designs total home solution, the Harmony II Wrap disrupts harmful electromagnetic waves throughout your home that can cause depression, behavioral disorders, weight gain, pain, sinus headaches, respiratory symptoms, etc. You may experience less yearly sickness and doctor visits, a deeper sleep, and a calming persona. All made possible with our Exclusive deionization process.
 
For music lovers, Harmony II Wrap is considered and has outperformed many high-end Audiophile power conditioners. The Wrap places your favorite artists and musicians in the room. A luxurious and spacious reproduction; powerful bass and a rich and engaging midrange; a top end that melts around the listener and draws you in; rich and vibrant sound that has scale and authority derived from a deep, ambient soundstage with exciting detail and dynamics.
 
Installation is super easy:
 
1. Locate your incoming electrical service conduit. Wrap will be installed 6-12 inches on the conduit BEFORE the meter (above or below, depending on how your service is delivered).
**NOTE: Do not remove plastic laminate! It is applied to protect the material and provide durability! **
 
2. Install the Wrap, non-labeled side facing IN, around the conduit as a cuff (overlapping layers) keeping the Wrap tight! Use the entire forty-two inches of Wrap!
**NOTE: Cement tape is applied to the Wrap to assist holding the Wrap in place during installation – peel and stick. **
 
3. Cover the Wrap with any rubberized tape to weatherize against the elements.
 
4. Allow up to 200-250 hours for the Wrap to initially condition your incoming electrical wiring in the home. It can take up to two full months for the electronics/appliances in the home to be fully conditioned.
 
NOTE: If this is your first Wrap purchased from us, just follow the installation instructions! If you own one of our previous model Wraps, remove the Wrap and install the Harmony II in its place. As a tip, use the old Wrap on the electrical panel. At the panel, open the door to reveal the individual circuit breakers. On the internal side of the panel door, cut and tape into place the old Wrap to cover the entire surface area of the panel door (use double-stick cement tape from your local hardware; it does the trick nicely and make the installation extremely easy). Use electrical tape to cover over the edges of the Wrap after it has been installed on the door. Use scissors to notch out the door latch.